Outdoor Living Today SSGS812 Bedienerhandbuch PDF herunterladen (Seite 20)

Toll Free 1-888-658-1658 www.outdoorlivingtoday.com sales@outdoorlivingtoday.com

Page 20

48. Where Ridge Boards meet, align together so they are

flush with each other and secure them with 12-1 1/4” screws.

To completely secure Ridge Boards, place 4 - 1 1/4” screws into

any of the remaining Metal Ridge Board Connectors holes.

Complete both sides.

49. With both Short and Long Rafters in correct

alignment, secure Gable framing to both outside

rafters with 7 - 2” screws per side at top and with 5

additional 2” screws into wall top plates at bottom.

Offsetting Metal Ridge Board Con.

Important: - If Gable framing does not

line up with Rafters, remove temporary 2”

screws from gable framing. Re-align

gable and secure with 8 - 2” screws total.

Complete

both Gables.

91”wide

51.Prior to securing the Long Rafter Side, make sure walls are aligned correctly. Have two helpers

push on both side walls at the top of wall from the outside until wall side plates are 91” apart from the

inside. When walls correctly aligned, attach long rafters using 3” screws as per Step 50. Position a

Roof Gusset on the Center Rafter. Leave a 1” gap from the top side of the rafter.

Leave 1” gap

to top of rafter

Roof Gusset

Center Rafter

50. Secure Short Rafters to Top Wall Framing

with one 3” screw per rafter. Screw through

Wall Frame at an angle.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 34 35

Keine Kommentare

Outdoor Living Today SSGS812 Bedienerhandbuch Seite 20